Non‐Invasive Salivary Electrochemical Quantification of Paraquat Poisoning Using Boron Doped Diamond Electrode

The present work describes the first electrochemical method for quantifying paraquat herbicide poisoning in human saliva samples. Paraquat shows two couples of well‐defined peaks in aqueous solution using a boron doped diamond (BDD) electrode. By using square wave voltammetry (SWV) technique under optimum experimental conditions, a linear analytical curve was obtained for paraquat concentrations ranging from 0.800 to 167 µmol L^?1, with a detection limit of 70 nmol L^?1. This method was applied to quantify paraquat spikes in human saliva samples and in two different water samples (tap and river). The recovery values obtained ranged from 83.0 to 104 % and 99.1 to 105 %, respectively, which highlight the accuracy of the proposed method.     

Photoelectrochemical Hydrogen Production in Alkaline Solutions Using Cu2O Coated with Earth‐Abundant Hydrogen Evolution Catalysts

The splitting of water into hydrogen and oxygen molecules using sunlight is an attractive method for solar energy storage. Until now, photoelectrochemical hydrogen evolution is mostly studied in acidic solutions, in which the hydrogen evolution is more facile than in alkaline solutions. Herein, we report photoelectrochemical hydrogen production in alkaline solutions, which are more favorable than acidic solutions for the complementary oxygen evolution half‐reaction. We show for the first time that amorphous molybdenum sulfide is a highly active hydrogen evolution catalyst in basic medium. The amorphous molybdenum sulfide catalyst and a Ni–Mo catalyst are then deposited on surface‐protected cuprous oxide photocathodes to catalyze sunlight‐driven hydrogen production in 1 M KOH. The photocathodes give photocurrents of ?6.3 mA cm^?2 at the reversible hydrogen evolution potential, the highest yet reported for a metal oxide photocathode using an earth‐abundant hydrogen evolution reaction catalyst.     

Interface Engineering of a CoOx/Ta3N5 Photocatalyst for Unprecedented Water Oxidation Performance under Visible‐Light‐Irradiation

Cocatalysts have been extensively used to promote water oxidation efficiency in solar‐to‐chemical energy conversion, but the influence of interface compatibility between semiconductor and cocatalyst has been rarely addressed. Here we demonstrate a feasible strategy of interface wettability modification to enhance water oxidation efficiency of the state‐of‐the‐art CoO_x/Ta₃N₅ system. When the hydrophobic feature of a Ta₃N₅ semiconductor was modulated to a hydrophilic one by in situ or ex situ surface coating with a magnesia nanolayer (2–5 nm), the interfacial contact between the hydrophilic CoO_x cocatalyst and the modified hydrophilic Ta₃N₅ semiconductor was greatly improved. Consequently, the visible‐light‐driven photocatalytic oxygen evolution rate of the resulting CoO_x/MgO(in)–Ta₃N₅ photocatalyst is ca. 23 times that of the pristine Ta₃N₅ sample, with a new record (11.3 %) of apparent quantum efficiency (AQE) under 500–600 nm illumination.     

NiSe Nanowire Film Supported on Nickel Foam: An Efficient and Stable 3D Bifunctional Electrode for Full Water Splitting

Active and stable electrocatalysts made from earth‐abundant elements are key to water splitting for hydrogen production through electrolysis. The growth of NiSe nanowire film on nickel foam (NiSe/NF) in situ by hydrothermal treatment of NF using NaHSe as Se source is presented. When used as a 3D oxygen evolution electrode, the NiSe/NF exhibits high activity with an overpotential of 270 mV required to achieve 20 mA cm^?2 and strong durability in 1.0 M KOH, and the NiOOH species formed at the NiSe surface serves as the actual catalytic site. The system is also highly efficient for catalyzing the hydrogen evolution reaction in basic media. This bifunctional electrode enables a high‐performance alkaline water electrolyzer with 10 mA cm^?2 at a cell voltage of 1.63 V.     

Single‐Crystal Semiconductors with Narrow Band Gaps for Solar Water Splitting

Solar water splitting provides a clean and renewable approach to produce hydrogen energy. In recent years, single‐crystal semiconductors such as Si and InP with narrow band gaps have demonstrated excellent performance to drive the half reactions of water splitting through visible light due to their suitable band gaps and low bulk recombination. This Minireview describes recent research advances that successfully overcome the primary obstacles in using these semiconductors as photoelectrodes, including photocorrosion, sluggish reaction kinetics, low photovoltage, and unfavorable planar substrate surface. Surface modification strategies, such as surface protection, cocatalyst loading, surface energetics tuning, and surface texturization are highlighted as the solutions.     

迎风通量差分分裂法对边界层特性的数值模拟

迎风通量差分分裂法作为一种高效率的数值方法,已被广泛地用于模拟各种复杂流场,但用这类方法模拟有边界层存在的超音速粘性流场时,必须保证通量差分分裂为守恒的;否则,将在边界层内引入一个可观的虚假人工扩散项和压力梯度项,歪曲了边界层特性。本文就这个问题进行理论和数值的研究。     

THREE HIGH-ORDER SPLITTING SCHEMES FOR 3D TRANSPORT EQUATION

IntroductionWith the development of modern industry, various pollutants discharge into the air,rivers, lakes and oceans, which makes the environmental qualities worse and has bad effectson the mankind’s health and the sustained development of industry an…     

飞秒激光参数对三态阶跃型分子Autler-Townes分裂的影响

利用三态模型和含时波包法, 研究了K₂分子在强飞秒泵浦-探测激光场中泵浦/探测场强、波长对光电子能谱Autler-Townes(AT)分裂的影响．通过分别改变两激光场的场强或者波长预测AT峰移和间距,并且首次量化了AT分裂的峰移和间距．光电子能谱在共振时显示为对称双峰,失谐时为非对称双峰。AT分裂间距随泵浦场强增大而增大,但不因探测场强改变而改变．     

A single-step HSS method for non-Hermitian positive definite linear systems

In this paper, based on the Hermitian and skew-Hermitian splitting (HSS) iteration method, a single-step HSS (SHSS) iteration method is introduced to solve the non-Hermitian positive definite linear systems. Theoretical analysis shows that, under a loose restriction on the iteration parameter, the SHSS method is convergent to the unique solution of the linear system. Furthermore, we derive an upper bound for the spectral radius of the SHSS iteration matrix, and the quasi-optimal parameter is obtained to minimize the above upper bound. Numerical experiments are reported to the efficiency of the SHSS method; numerical comparisons show that the proposed SHSS method is superior to the HSS method under certain conditions.     

An efficient splitting technique for two‐layer shallow‐water model

We consider the numerical approximation of the weak solutions of the two‐layer shallow‐water equations. The model under consideration is made of two usual one‐layer shallow‐water model coupled by nonconservative products. Because of the nonconservative products of the system, which couple both one‐layer shallow‐water subsystems, the usual numerical methods have to consider the full model. Of course, uncoupled numerical techniques, just involving finite volume schemes for the basic shallow‐water equations, are very attractive since they are very easy to implement and they are costless. Recently, a stable layer splitting technique was introduced [Bouchut and Morales de Luna, M2AN Math Model Numer Anal 42 (2008), 683–698]. In the same spirit, we exhibit new splitting technique, which is proved to be well balanced and non‐negative preserving. The main benefit issuing from the here derived uncoupled method is the ability to correctly approximate the solution of very severe benchmarks. © 2014 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 31: 1396–1423, 2015